BMW INSPECTION I

Download Microsoft word document

Undercarriage :

• Change engine oil and oil filter while engine is at operating temperature.
• Check transmission for leaks.
• Check rear axle for leaks.
• Half shafts: Check for leaks at flexible boots.
• Visually check fuel tank, lines and connections for leaks.
• Check power steering system for leaks. Check P/S fluid level; add fluid necessary.
• Check overall thickness of front and rear disc brake pads using special tool. Check thickness of parking brake linings only when replacing rear pads.
• Check brake (and clutch) system connections and lines for leaks, damage, and incorrect positioning.
• Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage and joint disc.
• Check all tire pressures (including spare). Correct if necessary. Check condition of tires (outer surfaces [left/right]), tread wear and pattern; in case of uneven tread wear readjust wheel alignment if requested

Engine Compartment :

• Read out diagnostic system.
• Check engine cooling system/heater hose connections for leaks. Check coolant level and antifreeze protection level; add coolant if necessary.
• Check level of brake and clutch fluid in reservoir. Add fluid if required.
• Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary.
• Replace microfilter(s).  Note : Reduce replacement interval in dusty operating conditions.
• Reset Service Indicator.

Body/Electrical Equipment :

• Check battery state-of-charge, and charge if required.
• Check exterior lights. Replace bulbs as necessary (Headlight and fog lamps extra cost).
• Check all warning/indicator lights.

Final Inspection :

• Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission.